The RetrieverTM TH Wet Kit model allows you to use the Wet Kit system on your semi tractor (if so equipped) and therefore eliminates the need for a 12-volt hydraulic power pack. If you have more than one semi-tractor with a Wet Kit it's easy to move the hitch from one tractor to another.
  


STORAGE BOXES
The Wet Kit model features two removable lid storage boxes that may be used for your implement towing accessories.


TWO-FUNCTION HYDRAULIC CONTROL VALVE
A two-function hydraulic control valve operates the Lift Mast raise and lower functions as well as the remote hydraulic outlets.


READY TO PLUMB
The Wet Kit model comes ready to plumb into your Wet Kit lines after you add the appropriate couplers for your specific wet kit set up. (couplers not included). Your couplers need to fit ¾" NPT threads.


CAT IV DRAWBAR
The optional CAT IV drawbar fits the drawbar receiver on the lift mast and allows towing the largest implements equipped with CAT IV hitches. A 2" hitch pin is included.


HIGH LIFT DRAWBAR
The optional Hi-Lift Drawbar uses the two-point hitch receivers to mount and allows lifting the drawbar approximately 40" from the ground for towing grain augers or other specialized equipment.


EASY FIVE MINUTE INSTALLATION
Installing and removing the Retriever® Transport Hitch from your semi-tractor takes as little as five minutes. This means maximum productivity and task flexibility with your heavy-duty trucks.
Wet Kit Model (for trucks equipped with Wet Kits)

Hyd. Control Valve - Two function valve, hitch raise/lower and remote valves

Hyd. Coupling - Hydraulic Quick Couplers with ¾" NPT threads are required to connect to truck Wet Kit lines but are NOT INCLUDED.

Storage Boxes - 2 Hinged Lid storage boxes are provided for accessories.

Shipping Weight - 1725 lbs.